纳米级BaAl_2O_4微粉的制备和性质

分别用溶胶 -凝胶法、低温固相反应法 ,制得了纳米级BaAl2 O4微粉 ,用电镜观察了其形貌和粒径的大小 ,用X-射线衍射仪进行了物相分析 ,测定了其纯度与晶型 ,讨论了制备方法与粒度大小的相互影响     

瞬态非傅里叶导热效应判据的探讨

讨论了通用傅里叶导热定律的数学模型,推导了半无限大物体在第一类边界条件下的基于非傅里叶导热定律的双曲线型偏微分方程的解析解。通过分析非傅里叶导热定律在瞬态条件下温度分布的变化过程,提出了非傅里叶导热效应的瞬态判据以及非傅里叶导热的作用范围,对研究工程中瞬态导热问题(如激光处理,电子束处理等)有重要意义。     

换热器小浮头螺栓断裂失效分析

针对换热器小浮头螺栓发生断裂的情况进行失效分析，找出原因，提出处理措施及材质选择时应注意的问题。     

Energy use in controlled temperature marine aquaculture

Temperature control offers benefits in land‐based marine aquaculture: stock growth rates may be enhanced by heating in winter; mortality rates in summer may be reduced by cooling. However, if the plant is not well designed, temperature control may create very large energy demands. This paper describes the application of temperature control in abalone aquaculture in New Zealand, with a focus on energy considerations in plant design. An abalone farm using a semi‐closed water conditioning system is used as a case study for which an energy model, based on a heat pump system, is developed. The model is used to determine the impact of plant design and tank conditions on the economics of the operation. Copyright © 2002 John Wiley & Sons, Ltd.     

螺旋焊管在线自动测径装置

螺旋焊管在线测径是生产高标准焊管的重要检测装置，可以实时监控钢管管径。选用CCD传感器与计算机连接，组成钢管测径装置，能够较好地达到对钢管管径实时监控的目的。     

Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

分离式热管换热器在脱硫装置的应用

介绍了分离式热管换热器的工作原理及其在工业脱硫装置中的应用，并不其余热回收情况与传统的二次中热方法相比较，阐明了其节能及环保作用。     

分户计量供暖节能住宅户型修正研究

针对多层住宅中不同户型在耗热量上的差异，引入户型体形系数修正各户的计量用热量，以计算和实测方法分析了一栋节能住宅不同围护结构户型的能耗特点，发现山墙、屋面、地面造成的不同户型之间的耗热量差别小于传统建筑；使用面积大的住户山墙造成的户型间耗热量差别小于使用面积小的住户。     

锅炉对流管爆裂原因分析

采用化学分析、金相检验及力学性能测定等方法，对锅炉对流管爆裂原因进行了分析。结果表明，长期超温运行而引起的蠕变是导致爆裂的主要原因。     

内循环好氧三相流化床处理造纸中段废水

本实验采用内循环好氧三相流化床处造纸中段废水，经过一段时间的驯化，获得了稳定的出水。CDO去除经保持在65％以上，系统对进水污染负荷的变化具有较大的承受能力。出水Cl^-的浓度有所增加，说明驯化后的微生物可能对有抽氯化物具有一定的降解作用。水气比在1／120至1／140之间可获得最好的COD去除效果。后进行絮凝处理后，出水COD降为60－80mg/L,BODo 50-60/L，色度为100－150CU，挥发性酚的质量浓度小于0．0265mg／L。